Using Revive

Performing a full Revive clean to repair and fix problems is straight forward, quick and easy to carry out and a preventative Service Shot treatment is even quicker to perform.

Sprayer-measurements

Starting with a cold engine, unclip the intake trunking after the airfilter.
(This 3 step process can be completed in just 10 minutes)

Spray Revive in 3 doses of 250ml into the intake, 1st with the engine running at 2200 RPM, next at 1800 RPM, stop the engine for 3 minutes, re-start the engine then finally at 2000 RPM.

Keep the engine running for a few more minutes until the Revive has worked out of the system.

Take the vehicle for a brisk drive of about 20 minutes, this allows Revive to do its work.
The Revive cleaning process can be performed before a service, this allows the vehicle to be checked over and filled with clean oil.

More videos on the Revive YouTube channel

Treatment Calculator